How To Cut A Hole In Glass

If you have a thick piece of tape you can just tape the surface directly. Ive drilled over 100 glass tanks and heres the easy way to do it.

Cut A Hole In A Glass Bottle Using A Soldering Iron Youtube

Begin at very low rpm to create a dimple in the glass then remove the cardboard and continue at about 400 rpm.

How to cut a hole in glass. Position the glass under the drill or position the drill on the glass where you want to drill. Youll need a drill a piece of wood and the following materials 1-inch bulkheads. A how-to video showing how to cut glass circles using the ST-210 Precision Circle Cutterhttpsbitly3bFDjLO.

Before you embark on drilling the main hole you should consider starting with a pilot hole. However the cutting wheel is offset from the edge of the cutter by about 18 inch. Video of the Day Step 1 Install a 38-inch diameter glass cutting bit into a power drill or a hand-held oscillating tool.

The glass should break along the line of the string when you hit it. Double check the speed of the drill. This will keep the glass from fracturing around the hole you create and itll keep the bit from slipping out.

Next mark the cut line onto the glass with a fine-tip indelible marker. The key is to use a carbide bit made especially for glass and tile. When you start the drilling process ensure that the hole is away from the edge of the plexiglass.

You can cut any tiles you want with a glass-cutter. Lay the glass on a flat surface and place a scrap of plywood slightly larger than the piece to be drilled underneath. The blow will be softer and the water will lessen the vibrations.

Measure and mark the spot on the glass where you want to place the hole. Drilling a hole in a pane of glass or a mirror is simple. Clamp the glass down with the C-clamps.

Tape a small scrap of dense cardboard to the glass. Doing it in the water achieves two things. Drilling holes in the double-pane glass is the first step to removing the condensation by allowing air to access the area.

Line the plywood with a rubber pad sheets of newsprint or some type of cushioning material. The pilot hole should be at least 12 the diameter of the final hole. Just see it as a piece of glass and when youve carried out the cut place the handle of the glass-cutter exactly under the cut and press down firmly on both sides.

To compensate for the offset subtract. First tape some cardboard around the part of the glass that youre going to drill. Start on a piece of cardboard.

If you have clamps you want to use them during this step. With the glass submerged take a firm stick and hit the glass below the point where you want to cut. Using wire to cut glass without a glass cutter is also easy.

The tile will break easily. Buffer the area between the glass and the clamp with the rubber.

How To Make A Hole In A Glass Bottle Crazy Invent